Mesa, AZ · ROC 334857 · ROC 334785 · Licensed, Bonded & Insured
Serving Customers in Mesa & Surrounding Areas
CALL OR TEXT
No heat in the house
Cold House?
Let's Find Out Why.

Emergency Heating & Furnace Repair in Mesa, AZ

JBEE Industries handles emergency heating repairs for Mesa homes when the furnace will not light, the heat pump blows cold air or the heater trips its breaker on a near freezing desert night. Call and describe what is happening, and we give you an honest answer about timing. A licensed technician then tracks down the failed ignitor, flame sensor, heat strip, reversing valve or control board and puts the repair price in writing before any work begins. No-heat calls come in from Mesa, Gilbert, Chandler, Queen Creek and nearby towns.
Rooftop package unit on a desert home
Smell gas in the house?
Get everyone outdoors, then phone the gas company or 911. Repairs come after the gas is shut off.
★  5.0 ★ Google Rating
★  ROC 334857 & 334785
★  Rebate Efficiency Arizona Contractor
★  $0 Free Estimates
●  Mesa
●  Gilbert
●  Chandler
●  Tempe
●  Queen Creek
●  San Tan Valley
●  Scottsdale
●  Gold Canyon
●  Phoenix
★  5.0 ★ Google Rating
★  ROC 334857 & 334785
★  Rebate Efficiency Arizona Contractor
★  $0 Free Estimates
●  Mesa
●  Gilbert
●  Chandler
●  Tempe
●  Queen Creek
●  San Tan Valley
●  Scottsdale
●  Gold Canyon
●  Phoenix
Before you pick up the phone

Quick Checks When the Heat Will Not Come On

Start at the thermostat. Confirm it is set to heat, the setpoint is a few degrees above room temperature and the display is not blank from dead batteries. Then look at the air filter. A filter caked with dust can trip a furnace safety switch or freeze a heat pump coil.
Next, check the breaker panel and the outdoor disconnect, and make sure the furnace door is fully closed, since a loose panel cuts the power. A heat pump that blows cool air for a few minutes and then warms up is just defrosting. Cold air that never stops is a call to us.
Package unit with duct transition on a tile roof
What usually fails

The Parts Behind Most No-Heat Calls in Mesa

Gas furnaces most often quit because of a cracked hot surface ignitor, a dirty flame sensor, a stuck inducer motor or a tripped limit switch. Electric furnaces and air handlers lose heat when a strip element burns out or a sequencer fails.
Heat pumps have their own list: a reversing valve stuck in cooling, a failed defrost board, a weak capacitor or a refrigerant leak. Because the same outdoor unit cools the house in summer, fixing it properly now protects your air conditioning in July.
What the technician tests first
01
Power at the breaker, disconnect and furnace switch
02
Ignition sequence, flame sensor and gas valve
03
Heat strip elements, sequencers and limit switches
04
Heat pump mode, defrost control and refrigerant pressures
How urgent is it?

Which Heating Problems Need a Call Right Away?

A few heating failures are safety issues. Others just leave you cold. Here is how we help you sort them when you call.
Get out and call
Gas smell or hissing
Leave the house, do not flip switches, and call the gas utility or 911 from outside before anything else.
Get out and call
Carbon monoxide alarm sounding
Get everyone into fresh air and call 911. The furnace stays off until a technician has tested it.
Get out and call
Electrical smell from the vents
Kill power to the heater at the panel. A melting wire or a failing blower motor should not keep running.
Call us today
Heat strip breaker keeps tripping
A shorted element, a loose connection or an undersized circuit can all trip it. Our electricians check the panel side too.
Call us today
Furnace clicks but never lights
Usually an ignitor, flame sensor or inducer problem. Resetting it over and over will not fix it.
Book a visit
Heat runs but rooms stay cool
Often a dirty filter, a leaky duct or a heat pump falling back on strips. Uncomfortable, but it can be scheduled.
When you call about no heat

From a Cold House to Warm Air at the Vents

01

Describe the symptom

Tell us what the heater is doing and where you live, and you get a straight answer about when we can come.
02

Find the real cause

The technician tests power, ignition, heat strips or heat pump controls before naming the problem.
03

Approve the price

The repair is quoted in writing, and nothing gets replaced until you agree to it.
04

Heat confirmed

We run a full heating cycle and check the air temperature at the registers before we pack up.
Old heater, big repair

A Straight Answer When the Heater Is Near the End

A no-heat night is a poor time to be talked into new equipment. We fix what failed when the fix is sound, and you get on with your week.
If the furnace has a cracked heat exchanger, or the heat pump compressor is gone on an older unit, we tell you plainly. You get the repair price and a replacement price side by side, financing options if you need them, and time to think it over in a warm house where possible.
What we weigh on an older heater
01
How old the furnace or heat pump really is
02
Whether the failed part is a safety item
03
Repair cost compared with a new system
04
Efficiency Arizona, SRP and APS rebates available
FAQ

No-Heat Questions From Mesa Homeowners

It can be. Mesa nights in December and January drop near freezing, and a cold house is a real risk for babies, older relatives, anyone who is ill, and pets. Call (480) 618-6969 and tell us who is home.

For a few minutes during defrost, that is normal. If it never warms up, the thermostat may be on cool, the reversing valve may be stuck, or the unit may be low on refrigerant. Switch to emergency heat if your thermostat has it, and call us.

The ignitor may be cracked, the flame sensor may be dirty, or the inducer motor may not be proving draft. After two or three failed tries most furnaces lock out for safety, so repeated resets will not help.

Our schedule changes from day to day, especially during a cold snap. Describe the problem, and you hear a realistic estimate of when a technician can reach you. We would rather be straight with you than overpromise.

Close doors to unused rooms, add layers and blankets, and gather in one room. Plug space heaters straight into a wall outlet, not an extension cord, and keep them away from bedding and curtains. Never heat the house with an oven, stove or grill.

The price comes down to the part that broke. A flame sensor or ignitor is a smaller job than a control board or a reversing valve. You see the price in writing before any work is done.

Only if it makes sense. If the heater is old or has a cracked heat exchanger, we price repair and replacement side by side and let you decide.

Close doors to unused rooms, add layers and blankets, and gather in one room. Plug space heaters straight into a wall outlet, not an extension cord, and keep them away from bedding and curtains. Never heat the house with an oven, stove or grill.

The price comes down to the part that broke. A flame sensor or ignitor is a smaller job than a control board or a reversing valve. You see the price in writing before any work is done.

Only if it makes sense. If the heater is old or has a cracked heat exchanger, we price repair and replacement side by side and let you decide.

Heater out right now?

Call JBEE and Get the Heat Back On

When the house is cold, calling beats filling out a form. Phone (480) 618-6969 and describe what the heater is doing. If the problem is minor and can hold until tomorrow, the form below works fine, and we will be in touch about scheduling.
Mesa
Scottsdale
Gold Canyon
Phoenix

Request Heating Service

Meant for problems that are not urgent. No heat at all? Please call.
Get Your Free Estimate