Mesa, AZ · ROC 334857 · ROC 334785 · Licensed, Bonded & Insured
Serving Customers in Mesa & Surrounding Areas
CALL OR TEXT
Builders and new homes
Wired Right
From the Slab Up.

New Construction Electrical Services in Mesa, AZ

JBEE Industries provides new construction electrical for builders, owner builders and families putting up a new home, casita or addition in Mesa and the East Valley. Our licensed electricians handle trenching and underground conduit, the meter base and panel, rough-in wiring, dedicated circuits and final trim, and because we also install HVAC and solar, those trades are planned in house. You get a written price before work begins and one company accountable for the power, the cooling and the panels on the roof.
Trench for new underground electrical conduit beside a home
One contractor, three trades
Electrical, HVAC and solar planned together means fewer handoffs on your build schedule.
★  5.0 ★ Google Rating
★  ROC 334857 & 334785
★  Rebate Efficiency Arizona Contractor
★  $0 Free Estimates
●  Mesa
●  Gilbert
●  Chandler
●  Tempe
●  Queen Creek
●  San Tan Valley
●  Scottsdale
●  Gold Canyon
●  Phoenix
★  5.0 ★ Google Rating
★  ROC 334857 & 334785
★  Rebate Efficiency Arizona Contractor
★  $0 Free Estimates
●  Mesa
●  Gilbert
●  Chandler
●  Tempe
●  Queen Creek
●  San Tan Valley
●  Scottsdale
●  Gold Canyon
●  Phoenix
Underground and service work

Trenching, Conduit and Service Entrance Before the Walls Go Up

New homes and detached casitas start with power that has to travel from the meter to the panel and out to the garage, pool equipment, RV pad or shop. We plan trench routes and conduit sizes so there is room to pull heavier wire later without digging up a finished yard.
Caliche and hard desert soil make East Valley trenching slow going, so getting the depth and route right the first time matters. Spare conduit for future solar, a battery or a detached garage costs little while the ground is still open.
New conduit run along a block wall
Rough-in to trim

A Wiring Plan Built Around How the Home Will Be Used

Before rough-in, we walk the plans with you to place outlets, switches, lights and fan boxes where furniture, counters and beds will actually go. Kitchen islands, home offices, media walls and garages get the circuits they need from day one.
Dedicated circuits are mapped for the range, dryer, AC condensers, air handler, mini splits, pool pump and a Level 2 EV charger. Since our own HVAC team sizes the cooling equipment, breaker and wire sizes follow the nameplate rather than a guess.
Circuits we plan on every new home
01
HVAC condensers, air handlers and mini splits
02
Range, dryer and kitchen appliance lines
03
Level 2 EV charger in the garage
04
Solar and battery space in the panel
What to decide and when

Which Electrical Decisions Must Be Made Before Drywall?

Some choices are cheap on an open frame and costly once the walls close. This is how we sequence them with builders and owners.
Decide before trenching
Service size and panel rating
200 amps is common in new homes, but solar, a battery and two EVs may justify planning for more.
Decide before trenching
Power for a casita or shop
Trench depth and conduit size decide how much power the outbuilding can ever have.
Decide before trenching
Solar and battery locations
Conduit paths from the roof and wall space for an inverter or Powerwall are easiest before stucco.
Decide before rough-in
Garage EV charger circuit
A 240 volt run to the garage wall during rough-in avoids surface conduit later.
Decide before rough-in
HVAC circuits and disconnects
Wire and breaker sizes follow the equipment, so the cooling plan and the wiring plan move together.
Can be added later
Fixtures, fans and dimmers
Fan rated boxes must go in now. The fixtures themselves can be picked closer to move in.
Can be added later
Whole-home surge protection
A panel mounted surge protector goes in easily at trim or any time after.
How a new build runs with us

From Plan Review to Final Inspection

01

Plan review

We go over the drawings, loads and future equipment, then price the electrical scope in writing.
02

Underground and service

Trenching, conduit, meter base and panel go in to match the stage of your build.
03

Rough-in wiring

Boxes, home runs and dedicated circuits are installed and ready for the city rough inspection.
04

Trim and final

Devices, fixtures and breakers are set, every circuit is tested and labeled, and the house is ready for final.
Power, cooling and solar together

Electrical, HVAC and Solar From One Licensed Company

On many new builds, the electrician, the HVAC installer and the solar company never talk until something does not fit. With JBEE, the same company sizes the AC, wires its circuits and leaves room in the panel for solar and a battery, so nothing gets redone at the end.
For homeowners, that means one number to call if anything needs attention after move in. For builders, it means one licensed, bonded and insured contractor covering electrical, HVAC and solar scope under Arizona ROC 334857 and ROC 334785.
What to send for a new build quote
01
Plans or a dimensioned floor plan
02
Expected HVAC equipment and locations
03
Any solar, battery or EV plans
04
Target dates for rough-in and final
FAQ

New Home Electrical Questions From East Valley Builders

Yes. We price new construction electrical for builders, owner builders and homeowners adding a casita or addition, from underground conduit through final trim.

Many new homes get 200 amp service. If you plan solar, a home battery, two EV chargers or an all electric kitchen and heat pump, a load calculation may point to more. We run the numbers with you before the meter base is ordered.

Yes. We leave space in the panel, run conduit toward the roof and the battery location, and install the garage EV circuit during rough-in. See how the pieces connect on our solar electrical integration page.

Yes. We trench, run conduit and feeders, set a subpanel and wire the building inside. Sizing the feeder up front for cooling, heating and any shop tools saves digging again later.

Yes. JBEE installs HVAC as well as electrical, which keeps the condenser, air handler and mini split circuits matched to the equipment. Read more about our new construction HVAC service.

It depends on square footage, circuit count, service size, trench length and the fixtures and devices chosen. Send plans for a free estimate, and the price arrives in writing before any work starts.

Mesa, Gilbert, Chandler, Queen Creek, San Tan Valley, Gold Canyon, Scottsdale, Tempe and Phoenix, including newer communities such as Eastmark.

Yes. JBEE installs HVAC as well as electrical, which keeps the condenser, air handler and mini split circuits matched to the equipment. Read more about our new construction HVAC service.

It depends on square footage, circuit count, service size, trench length and the fixtures and devices chosen. Send plans for a free estimate, and the price arrives in writing before any work starts.

Mesa, Gilbert, Chandler, Queen Creek, San Tan Valley, Gold Canyon, Scottsdale, Tempe and Phoenix, including newer communities such as Eastmark.

Building soon?

Get Your New Construction Electrical Priced

Send your plans through the form or call (480) 618-6969. We review the loads, the HVAC equipment and any solar or EV plans, then send a written electrical price so you can lock in the budget.
Mesa
Scottsdale
Gold Canyon
Phoenix

Request a New Build Quote

Share the city, home size and target start date.
Get Your Free Estimate