Mesa, AZ · ROC 334857 · ROC 334785 · Licensed, Bonded & Insured
Serving Customers in Mesa & Surrounding Areas
CALL OR TEXT
Blown-in fiberglass
Keep the Heat
Above the Ceiling.

Attic Insulation in Mesa, AZ

JBEE Industries installs blown-in fiberglass attic insulation for Mesa homeowners tired of hot bedrooms and an air conditioner that never shuts off in July. We measure what is in your attic now, top up thin, settled or disturbed areas to an even depth, and keep it clear of the air handler, ducts and wiring. As an HVAC and electrical contractor too, we check the whole attic, quote upfront and help you check Efficiency Arizona, SRP and APS rebate eligibility. Free estimates across the East Valley.
Attic air handler with ductwork and white drain lines between wood framing
Not sure what is up there?
We measure your current insulation during a free estimate and tell you honestly if it is already enough.
★  5.0 ★ Google Rating
★  ROC 334857 & 334785
★  Rebate Efficiency Arizona Contractor
★  $0 Free Estimates
●  Mesa
●  Gilbert
●  Chandler
●  Tempe
●  Queen Creek
●  San Tan Valley
●  Scottsdale
●  Gold Canyon
●  Phoenix
★  5.0 ★ Google Rating
★  ROC 334857 & 334785
★  Rebate Efficiency Arizona Contractor
★  $0 Free Estimates
●  Mesa
●  Gilbert
●  Chandler
●  Tempe
●  Queen Creek
●  San Tan Valley
●  Scottsdale
●  Gold Canyon
●  Phoenix
The hottest room in the house

Your Attic Bakes All Afternoon. Insulation Decides How Much Gets Through.

When Mesa highs pass 110, the space above your ceiling turns into an oven, and it keeps radiating heat well after sunset. Thin insulation lets that heat soak into the rooms below, so the AC chases the setpoint late into the night.
A deep, even layer of blown-in fiberglass slows that transfer. The house holds its temperature longer, the cooling system cycles less, and in January the same layer keeps furnace or heat pump warmth from escaping upward.
How attic heat reaches your living room
01
Sun heats the roof deck and attic air
02
Heat radiates down onto the ceiling drywall
03
Thin spots let it pass straight through
04
The AC removes it, one long cycle at a time
Why insulation wears out

A Well Insulated Attic in 2005 May Be Half Empty Today

Loose fill settles over the years, and every trip into the attic leaves a trail. Cable installers, roofers, pest control crews and solar installers walk paths through it, push it aside around boxes and leave bare ceiling joists showing.
Older homes around Dobson Ranch and central Mesa often started with less than today’s homes, and some were never topped up. Most homeowners never climb up to look, so they only notice through the bill and the warm back bedroom.
What we check before quoting insulation
01
Current depth and how evenly it covers
02
Damaged, wet or crushed areas
03
Clearances around the air handler and ducts
04
Wiring or junction boxes that need attention first
Signs of a thin attic

How a House Tells You It Needs More Insulation

Insulation hides above the drywall, so the clues show up in comfort and on the power bill. Here is what each one usually means.
Worth checking now
Back bedrooms stay hot
Rooms under the thinnest insulation or with the most sun exposure are first to fall behind on hot afternoons.
Worth checking now
AC barely shuts off in July
Attic heat adds load the system has to remove. A tune-up and an insulation check together tell you which is the bigger problem.
Plan before summer
Ceiling joists showing
If you can see the tops of the joists from the hatch, the layer is well below where it should be. Ask whether a rebate may apply.
Plan before summer
Attic disturbed by other work
Roof, solar or wiring jobs often leave crushed paths. We fix the insulation and can handle any wiring concern we find.
Bundle with other work
Replacing the cooling system soon
Insulate before the new unit goes in so it is sized for the improved home, not the leaky one.
Bundle with other work
Ducts sagging in the heat
Crushed or leaking ducts in a hot attic waste cooling before it reaches your vents.
How an insulation job runs

From the Attic Hatch to an Even, Measured Layer

01

Look and measure

We climb up, measure the existing depth and note damage, wiring or duct issues.
02

Recommendation and price

You get a straight answer on whether more insulation is worth it, with the price in writing.
03

Rebate check

We help you check Efficiency Arizona, SRP or APS eligibility before the job is booked.
04

Blow in and walk through

Fiberglass goes in evenly, the area is cleaned, and we show you the finished depth.
Insulation and your HVAC

Insulate First, Then Size the Next AC for the Better House

Because JBEE is also an HVAC contractor, we look at the air handler and ductwork while we are up there. A leaking plenum or crushed duct can waste as much cooling as thin insulation, and we tell you about it instead of covering it up.
If your system is near replacement, adding insulation first lowers the heat load, so the new heat pump or AC can be sized for the home you will have after the upgrade. Our licensed electricians can also handle any wiring concern we spot in the attic.
What happens on install day
01
Floors and the hatch area covered and protected
02
Fiberglass blown to an even, measured depth
03
Air handler, ducts and wiring kept clear
04
Work area cleaned and the result walked through with you
FAQ

Attic Insulation Questions We Get in Mesa

Blown-in fiberglass fills around joists, wiring and odd corners without the seams and compressed spots batts often leave, and it can be added on top of existing insulation. For most Mesa attics, that makes it the practical way to reach an even, full depth.

Energy.gov publishes recommended attic levels by climate zone, and many older East Valley attics sit well below them. We measure what you have during a free estimate and tell you how far it is from where it should be.

Usually, yes. If the existing layer is dry and intact, blown-in fiberglass can go right on top. Wet, moldy or badly damaged sections should be dealt with first, and we tell you before the job starts.

In an under-insulated attic, it reduces the heat your AC has to remove, so the system usually runs less. Results depend on the home and your current insulation, so we do not promise a set savings figure. We will tell you if we think it is not worth doing.

There may be. Insulation is one of the upgrades the Efficiency Arizona program covers, JBEE is approved to work with it, and utilities run separate efficiency offers too. See our rebates page for program details, and we check current eligibility with you before work begins.

Timing depends on attic size, access and whether any prep work, such as clearing damaged material, is needed. We give you a clear plan with the estimate.

Yes. Ask about payment plans for an attic upgrade and we will walk through them during your free estimate along with the written price, so you can decide with all the numbers in front of you.

There may be. Insulation is one of the upgrades the Efficiency Arizona program covers, JBEE is approved to work with it, and utilities run separate efficiency offers too. See our rebates page for program details, and we check current eligibility with you before work begins.

Timing depends on attic size, access and whether any prep work, such as clearing damaged material, is needed. We give you a clear plan with the estimate.

Yes. Ask about payment plans for an attic upgrade and we will walk through them during your free estimate along with the written price, so you can decide with all the numbers in front of you.

Hot rooms, high bills?

Have a Licensed Team Measure Your Attic

Phone (480) 618-6969, or fill out the request form here. We will look at your attic insulation, the air handler and ducts above your ceiling, give you an honest recommendation and a written price, and help you check whether a rebate may apply.
Mesa
Scottsdale
Gold Canyon
Phoenix

Request an Insulation Estimate

Tell us your city and which rooms run hottest.
Get Your Free Estimate